I should have started by removing these two screws
Click the thumbnail to see the full-sized image
But I actually started with two of these screws, removed the knee board, then removed the third screw
Click the thumbnail to see the full-sized image
I removed the ignition assembly by removing these three screws. There is a large bump on the bottom, this is where the spring that lifts the ignition locking mechanism goes
Click the thumbnail to see the full-sized image
Click the thumbnail to see the full-sized image
The piece of ignition that had broken
Click the thumbnail to see the full-sized image
Replacement part. The marked part is very delicate and will snap easily
Unless otherwise stated, our shows are released under a Creative Commons Attribution-ShareAlike 3.0 Unported (CC BY-SA 3.0) license.
The HPR Website Design is released to the Public Domain.